DIN 1.6657 14NiCrMo13-4 16NCD13 832M13 EN36C Case Hardening Alloy Steel Bar
1. EN36C Application
EN36C is a 3.50 % Nickel steel with Chromium & Molybdenum. It is a carburizing steel grade with very high surface strength with a soft but strong core. The material retains an incredible degree of toughness and fatigue resistance. EN36C can be used to make gear parts exposed to highest stresses and wear conditions. Typical components include gears, planet wheels, drive pinions, shafts, bushes and sleeves. Results in high core strength and excellent toughness in the components and is very suitable for parts with large diameter.
2.All Grades Comparison
DIN | EN | ANFOR | BS |
---|---|---|---|
1.6657 | 14NiCrMo13-4 | 16NCD13 | 832M13 / EN36C |
3.Quality Standard
EN 10084 Case hardening steels
DIN17210 Case hardening steels
AS1444 Wrought alloy steels
4.Chemical Composition(%)
EN36B0.12-0.180.30-0.600.35 max0.025 max0.025 max0.60-1.103.00-3.75EN36C0.12-0.180.30-0.600.35 max0.025 max0.025 max0.60-1.103.00-3.750.10-0.25
Steel Grade | C | Mn | Si | P | S | Cr | Ni | Mo |
---|---|---|---|---|---|---|---|---|
14NiCrMo13-4 | 0.11-0.17 | 0.30-0.60 | 0.40 max | 0.025 max | 0.025 max | 0.80-1.10 | 3.00-3.50 | 0.20-0.30 |
EN36A | 0.10-0.16 | 0.35-0.60 | 0.35 max | 0.025 max | 0.025 max | 0.70-1.00 | 3.00-3.75 | / |
5.Mechanical Properties(T=20°C if not differently stated)
Process | Tensile Strength Rm (Mpa) | Elongation A5 (%) | Impact Value Kv (J) Room Temperature | Hardness (HB) | |
---|---|---|---|---|---|
SOFT ANNEALED | / | / | / | / | 217 max |
QUENCHED AND TEMPERED | 1230-1480 | 9 min | 35 min | / | 368-424 |
6.HEAT TREATMENT:
- Soft Annealing: Heat EN36C to 825oC, cool slowly. This will produce a maximum Brinell hardness of 217.
- Hardening: Harden from a temperature of 825-850oC, followed by oil or quenching.
- Tempering:– After carburising and hardening, the steel is tempered between 140°C and 200°C as required.
For use in the non carburised heat treated condition, temper in accordance with properties required.
7.Welding:
Pre-heat welding area to 250-450°C and maintain this temperature while welding with a low hydrogen electrode. Cool at a maximum rate of 100°C per hour. Do not weld after carburising.
8.Mill′s test certificate:
EN 10204/3.1 with all relevant data reg. chem. composition, mech. properties and results of testing.