Archive for the FAQ Category

How About H13 steel vs 4140 Steel   4140 steel and SAE-AISI H13 steel are iron alloys. They have a moderately high 93% of their average alloy composition in common. There are 23 material properties with values for both materials.   What is H13 Tool Steel? H13

How About D2 Steel VS 8Cr13MoV Steel   What is D2 Steel? D2 Steel – This steel This is not technically Stainless, but Tool Steel. However, it Because of this it has good rust resistance. It is much tougher than most stainless steels, but not as tough

how about 440c steel vs d2 steel   What is 440c Steel Especially 440c stainless steel is a high carbon martensitic stainless steel. That comes with high strength, moderate corrosion resistance, and perfect hardness and wear resistance.   On the other hand, it is capable of attaining,

D2 Steel Heat Treatment D2 steel has high wear resistance, micro-deformation cold work die steel, wind hard tool steel, carbon content up to 1.5%, chromium content up to 11.5%, heat treatment hardness up to 60HRC. D2 steel can be used to produce cold work die steel with

What Exactly Is Weathering Steel And What Are Its Application? Weathering steel is a type of low carbon steel that incorporates additional alloying elements in addition to carbon and iron atoms. Weathering steel has greater strength and corrosion resistance than normal low carbon steel grades owing to

What Is the difference between Hole Punching, Notching, and Drilling? Plate and Sheets undergo a variety of operation during its fabrication, all this is needed to fulfil a certain requirements. Material removal is a method of fabrication process that is widely used. Hole punching, notching, and drilling

ISO 9001 Certification Benefits and Importance Checks and balances must be in place in a global marketplace. Or else, maintaining continuity and efficiency across sectors and nations will be impossible. ISO is one such entity that contributes to maintaining International Standards in a fair playing field.  

Measuring Metal Strength : Tensile Strength and Impact Strength Tensile strength and impact strength are two of the most important factors to consider when choosing a metal for a particular project, particularly when it comes to structural applications. It’s critical to understand these mechanical properties and how

Turned, Ground and Polished: Meaning and Applications Metal shafts are used of Higher Speed applications which need a higher-level of precision. Premature wear on either the shaft or the bearing will occur if the shafts has a rough finish or lack concentricity and straightness. Steel shaft manufacturers

Difference between Annealing and Tempering The difference between annealing and tempering is determined by how it is treated. Tempering the metal entails heating it to a certain heat below a certain threshold and then cooling it at a very slow and regulated rate, while annealing involves heating